All Products / Adhesive Equipment / Hot Melt Roll Coaters /Basic Hot Roll Series Hot Melt Roll Coaters


Datco Basic Hot Roll Coater 6"
Part Number: Datcobasic6
SKU: Datcobasic6
SAVE $165.00
REG. $2,200.00
Datco Basic Hot Roll Coater 12"
Part Number: Datcobasic12
SKU: Datcobasic12
SAVE $200.00
REG. $2,600.00


Standard lead time is approximately 3-7 days.

The Datco “Basic” Hot Roll uses the same roll and reservoir as the full-feature Hot Roll. The difference is the drive and temperature control package. The basic machine is available in 6″ and 12″ roll lengths.


Constant-speed Brother International GTR gear motor
Autonics plug in modular analogue temperature control located inside the panel box.
120 volt AC power requirement

The control panel is simple and straightforward, featuring an illuminated main power switch, a motor start-stop switch, and a knob to set the temperature. As with all Datco roll coaters, there is an electronic under-temperature circuit to prevent the motor from attempting to run until the unit has achieved setpoint temperature.

The Basic Roll is easy to use and easy to own. Simply plug it into almost any 120 volt outlet, set the temperature, and turn it on. When it’s up to temperature, the motor is enabled, and you are ready to start.


6”: 40 lbs. (18 kilo.)
12”: 50 lbs. (22 kilo.)

6”: 18”x12”x8” (46x30x20 cm.)
12”: 30”x12”x8” (60x30x20 cm.)

.Reservoir Volume:
6”: 82 cu. in. (208 cu. cm.)
12”: 165 cu. in. (419 cu. cm.)

Temperature range: Ambient- 400 F (204 C)

Power supply: All Basic Rolls are 120 V.

Please enable JavaScript for this website to fully function. 秒速飞艇技巧 秒速飞艇开奖官方网站 SG飞艇网上 秒速飞艇软件下载 澳洲幸运8历史走势图 极速赛车开奖直播 秒速飞艇开奖官方同步 澳洲8开奖号码 澳洲幸运5投注平台